Battery Replacement - V7 UPS1500RM2U Bedienungsanleitung

1.4 Setup
1. UPS input connection
Plug the UPS into a grounded receptacle only. Avoid using extension cords, power strips or surge protectors
2. UPS output connection
There are two kinds of outputs: programmable outlets and general outlets. Please connect non-critical devices to the
programmable outlets and critical devices to the general outlets. You may extend the backup time to critical devices by
setting shorter backup time for non-critical devices
3. Communication connection (Optional)
USB Port
To allow for unattended UPS shutdown/start-up and status monitoring, connect the included USB cable from the
computer to the UPS system
Note: USB port and RS-232 port can't work at the same time.
4. Network connection
Network/Fax/Phone surge port
Connect a single modem/phone/fax/network line into surge-protected "IN" outlet on the back panel of the UPS unit.
Connect from "OUT" outlet to the equipment with another modem/fax/phone/network line cable.
5. Disable and enable EPO function
This UPS is equipped with EPO function. Pin 1 and Pin2 are closed by default for normal UPS operation.
Note: The EPO function logic can be set up via LCD setting. Please refer to program 16 in UPS setting for the details
Method 1
Remove two top screws
Method 2
Remove two front screws
Downloaded from www.Manualslib.com
Pull out metal pin
Pull out the entire green connector
manuals search engine
6. Turn on the UPS
Press the ON/Mute Button on the front panel for two seconds to power on the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not expect full battery run
capability during this initial charge period
7. Install software (Optional for advanced users)
For optimal computer system protection, install UPS monitoring software to fully configure the UPS system. Please
follow steps below to download and install monitoring software.
1. Go to the website http://www.V7-world.com/downloads
2. Select ViewPower software for your operating system to download the software.
3. Follow the on-screen instructions to install the software.

1.5 Battery Replacement

Note: This UPS is equipped with internal batteries and only a trained technician should replace the batteries.
Caution! – Adhere to all warnings, cautions, and notes before replacing batteries.
Note: When battery is disconnected, equipment is not protected from power outages.
1
Remove front panel
3
Pull out the battery box by removing two screws
on the front panel
5 6
Remove the top cover of battery After replacing the batteries,
box and replace the inside put the battery box back to the
batteries its original location and screw it
tightly
2
Disconnect battery wires
4
Remove the top cover of battery box and replace
the inside batteries
7
Put the front panel back on the unit