Rear Panel View; Rack-Mount Installation; Tower Installation - V7 UPS1500RM2U Bedienungsanleitung

1.1 Rear Panel View

Note: Before installation, please inspect the unit. Be sure that nothing inside the package is damaged.
Please keep the original package in a safe place for future use.
IEC Type
1. Programmable outlets: connect to non-critical loads
2. Output receptacles: connect to mission-critical loads
3. AC input
4. Network/Fax/Modem surge protection
5. Emergency power off function Connector (EPO)
6. USB communication port
1.2 Operation
The UPS is composed of mains input, EMI/RFI Filters, Inverter, Battery charger, DC-to-DC converter, battery,
AVR TX and UPS output
1.3 Installation
For safety consideration, the UPS is shipped out from factory without connecting battery wires. Before
installation of the UPS, please follow the steps below to re-connect the battery wires.
Remove Front Panel
Downloaded from www.Manualslib.com
NEMA Type
Output
AVR
EMI/RFI
Inverter
TX
Filters
DC-to-DC
Converter
Battery
Battery
Charger
Connect the AC Input and re-connect Put the front panel back
battery wires on the unit
manuals search engine

Rack-Mount Installation

Caution! – DO NOT use the mounting brackets to lift the unit. The mounting brackets are only
for securing the unit to the rack.
Cage Fixing
Nuts (6) Studs (4) Screws (8)
M6
Screws

Tower Installation

1 2
M6
Fixing
Studs
3 Cage
Nuts
3
Note: When installing the
UPS or battery pack with feet,
please keep 70mm distance
from the edge of the unit
3 Cage
Nuts