Athena GET WiFi-COM Handbuch Seite 6

4.
Start the engine; WiFi-COM
will be powered. After a few
moments, the red and green
LEDs will turn on, indicating a
correct power supply and that
the WiFi signal is activated.
ATTENTION:
-If the LEDs start to flash, this
indicates an error. Make sure
to have correctly carried out
the preliminary operations
indicated above. Then turn the
motorcycle off and back on to
restart the device.
-If you want to operate the
device keeping the engine
off, the wiring GL-0170-AA
(sold separately) is available
that permits powering the
WiFiCOM by connecting it
to a completely charged 12
V battery.
5.
Access the phone/tablet
settings and connect to the
Wifi network indicated on the
label on the back of the device
and at the end of this manual.
Enter the password located
on the label to establish the
connection between WiFiCOM
and the phone/tablet.
ATTENTION:
-If the WiFi signal is lost, make
sure that WiFiCOM is actually
on and connected to the
phone/tablet.
-The connection between the
phone/tablet and
is only possible within
maximum distance of 5 metres.
A greater distance will slow
down the communication
between the devices or cause a
total loss of connection.
-A failed connection between
the phone/tablet
WiFiCOM may be due to poor
weather conditions.
6
6.
Start the WiGET app on your
phone/tablet.
Discover how to use all the
functions
app by watching this video:
ht tps://w w w.youtube.com/
watch?v=P_RHvewtHSs
WiFiCOM
a
and
of the WiGET
EN