Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Informations:
1. Test completeness of the fancy-box - see illustration on page 1.
2. Remove the roof carrier from the car when not in use (cw-factor) or by using an automatically
car wash.
Recommendations:
1. Assembling of the roof carrier following the users information.
2. Fastening-items, possibly given by the vehicle manufacturers (see operating instructions of
the vehicle) or by Atera, have to be followed absolutely!
3. First fix the roof carrier, then fix accessories!
4. It is absolutely essential that the bolt connections, particularly the connections between the
roof rack and the securing elements, are checked for the first time after a short journey, and
then subsequently at regular intervals depending on the road! Check-up on each remounting!
5. Carrier and accessories cleaning and regular maintenance of threads (oil, grease) is
recommended. Important! Do not use high-pressure or steam jet methods for cleaning the
parts and on no account cold cleaners or similar alkaline products. If the zinc coating is
damaged, there is a risk of the parts rusting. Attention: protect rubber and plastics against
touch with gasoline, oil, grease and other chemical products. Cleaning of the roof and the
carrier is recommended before each remounting (lac damages and so on).
6. For the original Atera roof carrier systems as from Atera imported articles, we will take
over the full warranty, if it is a question of defectivly produced material. The part inquestion
have to be send back, free of any charge, to all the expenses. Please read the users
information which is packed with every article. In case of any claim, you have to send back
the users information and the purchase receipt.
7. We manufacture following DIN 75302 + ISO/IEC Guide 37-1983 resp. Australian
Standard 1235-1991.
For all changes out of our engineering instructions or purposes other then originally intend
we assume no responsibility. Our article are being constantly observed and developed
forward. All changes at any time reserved.
8. We are not responsible for incorrect montage or deficient use.
Warnings!
1. The vehicle handles differently (vulnerability to side wind, cornering, breaking) when a roof
rack is fitted and especially when it is loaded.
2. The loading of the rack should distribute the weight evenly and produce the lowest possible
centre of gravity. Items of luggage must not protrude out from the load-carrying surface to
any great extent (danger of injury, damaging of the rear-flap).
3. Do not exceed the licenced roof load indicated by the vehicle manufacturer or Atera.
Licenced roof load = weight roof carrier + accessories + load.
4. Only the driver of the car is responsible for the roof carry and its loading!
5. For safety use special straps!
Hersteller/Manufacturer:
Eberhard Tittel GmbH
Postfach 2240
D-88192 Ravensburg
4
Telefon (0751) 7604-0
Telefax (0751) 7604-76
E-Mail: info@atera.de
Web:
www.atera.de
Werbung
