Boil-Dry Protection - Philips HD4646 Bedienungsanleitung

English
introduction
Congratulations on purchasing this Philips kettle! In
this user manual you find all the information you need
to enjoy your kettle optimally for a long time.
general description (Fig. 1)
A On/off switch (I/O)
B Lid
C Spout
D Water level indicator
E Base
F Scale filter (HD4646/HD4628 only)
important
Read this user manual carefully before you use the
appliance and save it for future reference.
Danger
- Do not immerse the appliance or the base in water
or any other liquid.
Warning
- Check if the voltage indicated on the appliance
corresponds to the local mains voltage before you
connect the appliance.
- Do not use the appliance if the plug, the mains cord,
the base or the appliance itself is damaged.
- If the mains cord is damaged, you must have it
replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid
a hazard.
- This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
- Children should be supervised to ensure that they
do not play with the appliance.
- Keep the mains cord out of the reach of children.
Do not let the mains cord hang over the edge of
the table or worktop on which the appliance stands.
Excess cord can be stored in or around the base of
the appliance.
- Only use the kettle in combination with its original
base.
- Hot water can cause serious burns. Be careful when
the kettle contains hot water.
- Keep the mains cord, the base and the kettle away
from hot surfaces.
- Never fill the kettle beyond the maximum level
indication. If the kettle has been overfilled, boiling
water may be ejected from the spout and cause
scalding.
- Do not open the lid while the water is heating up. Be
careful when you open the lid immediately after the
water has boiled: the steam that comes out of the
kettle is very hot.
Caution
- Do not touch the body of the kettle during and
some time after use, as it gets very hot. Always lift
the kettle by its handle.
- Always place the base and the kettle on a dry, flat
and stable surface.
- The kettle is only intended for boiling water. Do not
use it to heat up soup or other liquids or jarred,
bottled or tinned food.
- HD4646: Always make sure the water in the kettle at
least covers the bottom of the kettle to prevent the
kettle from boiling dry.
- HD4638/HD4628/HD4626: Never fill the kettle
below the minimum level to prevent the kettle from
boiling dry.
- Depending on the hardness of the water in your
area, small spots may appear on the heating element
of your kettle when you use it. This phenomenon is
the result of scale build-up on the heating element
and on the inside of the kettle over time. The harder
the water, the faster scale builds up. Scale can occur
in different colours. Although scale is harmless, too
much scale can influence the performance of your
kettle. Descale your kettle regularly by following the
instructions given in the chapter 'Descaling'.
- Some condensation may appear on the base of the
kettle. This is perfectly normal and does not mean
that the kettle has any defects.
4222.001.9735.4

Boil-dry protection

This kettle is equipped with boil-dry protection. This
device automatically switches off the kettle if it is
accidentally switched on when there is no water or not
enough water in it. The on/off switch stays in 'on' position.
Set the on/off switch to 'off ' and let the kettle cool down
for 10 minutes. Then lift the kettle from its base to reset
the boil-dry protection. The kettle is now ready for use
again.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user
manual, the appliance is safe to use based on scientific
evidence available today.
Before first use
1 Remove stickers, if any, from the base or the kettle.
2 Place the base on a dry, stable and flat surface.
3 HD4646 only: To adjust the length of the cord, wind
it round the reel in the base.
4 Pass the cord through one of the slots in the base.
5 Rinse the kettle with water.
6 Fill the kettle with water up to the maximum
level and let the water boil once (see 'Using the
appliance').
7 Pour out the hot water and rinse the kettle once
more.
Using the appliance
1 Fill the kettle with water either through the spout
or through the open lid (Fig. 2).
2 If the lid is open, close the lid.
Make sure that the lid is properly closed to prevent the
kettle from boiling dry.
3 Place the kettle on its base, put the plug in the wall
socket.
- HD4628/HD4626: Set the on/off switch to 'I' (Fig. 3).
- HD4638: Set the on/off switch to 'I' (Fig. 4).
- HD4646: Set the on/off switch to 'I' (Fig. 5).
The kettle starts heating up.
,
The kettle switches off automatically when the
,
water has reached boiling point.
Note: You can interrupt the boiling process by pressing the
on/off switch to 'O'.
Cleaning and descaling
Always unplug the appliance before you clean it.
Never use scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the
appliance.
Never immerse the kettle or its base in water.
Cleaning the kettle
1 Clean the outside of the kettle with a soft, damp
cloth moistened with warm water and some mild
cleaning agent.
Cleaning the filter (HD4646/HD4628
only)
Scale is not harmful to your health but it may give your
drink a powdery taste. The scale filter prevents scale
particles from ending up in your drink. Clean the scale
filter regularly.
1 Remove the filter from the kettle (1) and gently
brush it with a soft nylon brush under a running tap
(2) (Fig. 6).
Note: You can also leave the filter in the kettle when you
descale the whole appliance (see section 'Descaling the
kettle' in this chapter).
Note: You can also take the filter out of the kettle and clean
it in the dishwasher.
Descaling the kettle
Regular descaling prolongs the life of the kettle.
In case of normal use (up to 5 times a day), the following
descaling frequency is recommended:
- Once every 3 months if you use soft water (up to
18dH).
- Once every month if you use hard water (more than
18dH).
1 Fill the kettle with water up to three-quarters of
the maximum level and bring the water to the boil.
2 After the kettle has switched off, add white vinegar
(8% acetic acid) to the maximum level.
3 Leave the solution in the kettle overnight.
4 Empty the kettle and rinse the inside thoroughly.
5 Fill the kettle with fresh water and boil the water.
6 Empty the kettle and rinse it with fresh water again.
7 Repeat the procedure if there is still some scale in
the kettle.
Note: You can also use an appropriate descaler. In that case,
follow the instructions on the package of the descaler.
Replacement
If the kettle, the base or the mains cord of the appliance
is damaged, take the base or the kettle to a service
centre authorised by Philips for repair or replacement
of the cord to avoid a hazard.
You can purchase a new filter at your Philips dealer or
at a Philips service centre. The table below indicates
which filters are suitable for your kettle.
Kettle type Filter type
HD4646 HD4987
HD4628 HD4966
Environment
Do not throw away the appliance with the normal
,
household waste at the end of its life, but hand it in
at an official collection point for recycling. By doing
this, you help to preserve the environment (Fig. 7).
guarantee & service
If you need information or if you have a problem, please
visit the Philips website at www.philips.com or contact
the Philips Customer Care Centre in your country
(you find its phone number in the worldwide guarantee
leaflet). If there is no Customer Care Centre in your
country, go to your local Philips dealer or contact the
Service Department of Philips Domestic Appliances and
Personal Care BV.
2/7