Troubleshooting - CIMCO 11 1406 Bedienungsanleitung

4. Screw and fasten the battery cover with the screw.


troubleshooting

In purchasing the DMM, you have acquired a product which has been designed to the state of the art
and is operationally reliable.
Nevertheless, problems or faults may occur. For this reason, the following is a description of how you
can eliminate possible malfunctions yourself.
Error
The DMM does not work.
No measuring change.
40
Bedienungsanleitung zu 111406.indd 40
Only use alkaline batteries, since these are powerful and have a long life.
always observe the safety instructions!
repairs other than those described should only be carried out by an
authorised specialist.
if you have queries about handling the measuring device, our
technical support is available under the following telephone number:
CimCO-Werkzeugfabrik Carl Jul. müller gmbH & Co. Kg
telefon: +49 2191 37 18 01 · email: info@cimco.de
Possible cause
Is the battery dead?
The HOLD function is
activated (display shows "H")
Is the wrong measuring
function active (AC/DC)?
Did you use the wrong
measuring sockets?
Is the fuse defect?
Remedy
Check the status.
Press the button "HOLD"
again. The symbol "H"
disappears.
Check the display (AC/DC)
and switch the function if
applicable.
Check the measuring sockets.
In A/mA/µA range: Change the
fuse as described in the chapter
"Changing the fuse".
8/1/2017 10:24:45 AM