Calibrate The Dial Gauge; Measuring - SkiTuning Baseman Originalbetriebsanleitung

5. Calibrate the dial gauge
1. Switch on the dial gauge
2. Put the BASEMAN on a straight surface, adjust the support angle upwards with the adjusting
nut (straightedge fully lies upon) ATTENTION: the straitedge has to bear on the surface picture 4
3. Adjust the dial gauge on mm with the "mm/inch"-button
4. Set the dial gauge to zero with the "Zero"-button

6. Measuring

1. Switch on the LED-lamp.Put the BASEMAN on a straight surface, adjust the support angle up-
wards with the adjusting nut (straightedge fully lies upon), picture 4
2. Set the BASEMAN in a 90 degree angle to the bottom angle upon the base
3. Position the straightedge-marking between the base and the edge, picture 6
4. Gently push the straightedge with the index finger and thumb. With outward rotation of the
adjusting nut...
5. ... set the angle of support and stop rotating the adjusting nut when no light shines through.
Picture 7
6. Read the bottom edge angle from the dial gauge (1mm = 1 degree)
90°
picture 5
picture 4
picture 6
picture 7
11