Herunterladen Inhalt Inhalt Diese Seite drucken

Speaker Installation; Speaker Connection - Kruger & Matz KM0503 Bedienungsanleitung

Home speakers
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

SPEAKER INSTALLATION

Except the speaker units' quality, the acoustic quality of the speaker system also
depends on factors like the size and mode of rooms, speaker installation means
and so on. Thus, please pay attention to the following points during installation:
• When the speaker is placed directly on the floor, the subwoofer effect will be too much
obvious. Then one cement board or other hard support plate should be needed to be
placed on the floor.
• Attention: when the speaker and the sound source or the amplifier are placed on the
same support object, the speaker may blare screams.
• If there are walls or glass door behind or before the speaker system in the short
distance, please note that heavy and strong curtains should be needed on the wall or
the glass door in order to avoid unnecessary resonance and reverberation effect.
• This model speaker system is with antimagnetic design. For common television
receiver, it can stand near the speaker without bad TV image result. But for some
television, maybe the speaker is too close to it and results in image color damage.
When this situation happens, please move the speaker a little away from the
television.
• Attention: if there is magnetic field or equipment that creates strong magnetic field,
it possibly results in television image damage because of the interaction between the
equipment and the speaker.

SPEAKER CONNECTION

Please make sure that the amplifier is power-off before connecting the speaker
system.
• Common connection mean
Use the speaker cable to connect the terminals of the speaker rear side to the
terminals of the amplifier. (Connection mean as illustrations show) Please connect
the left channel of the speaker to "L" terminal of the amplifier, and the right channel of
the speaker should be connected to "R" terminal of the amplifier. Attention to the mark
of positive pole and negative pole (with corresponding "+" and "-"). The invertion of
positive pole and negative pole results in sound distortion.
6
Owner's manual

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Km0504

Inhaltsverzeichnis