Important Safeguards For All Electrical Appliances - SOLIS PRESTIGE Blender 837 Bedienungsanleitung

IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES

• Fully unwind the cord before use.
• To protect against electric shock, do not
immerse the cord, plug or motor base in water
or any other liquid.
• Do not allow the cord to hang over the edge of
a table or counter, touch hot surfaces or become
knotted.
• This appliance is not intended for use by young
children or infirm persons unless they have been
adequately supervised by a responsible person
to ensure they can use the appliance safely.
• Young children should be supervised to ensure
that they do not play with the appliance.
• I t is recommended to regularly inspect the
appliance. Do not use the appliance if the power
supply cord, plug or appliance becomes dam-
aged in any way. Return the entire appliance to
the nearest authorised Solis Service Centre for
examination and/or repair.
OPERATING YOUR SOLIS PRESTIGE BLENDER
Before first use
Before using your Solis Prestige Blender for the
first time, remove any packaging material and
promotional labels. Ensure the appliance is
switched off at the power outlet and the power
cord is unplugged.
Wash the lid, inner lid, blender jug and blade
assembly (refer to Disassembling the blender jug
on Page 38) in warm, soapy water with a soft cloth.
Rinse and dry thoroughly. The motor base can be
wiped with a damp cloth. Dry thoroughly.
E
• When using your Solis Prestige Blender for the
first time, you may notice an odour coming
from the motor. This is normal and will dissipate
with use.
• The blending blades are extremely sharp. Avoid
any contact with fingers and hands.
Assembling and attaching the blender
Step 1.
Place the motor base on a flat, dry surface such
as a bench top. Ensure that the motor base is
switched off at the power outlet and the power
cord is unplugged.
36
• Any maintenance other than cleaning should be
performed at an authorised Solis Service Centre.
• This appliance is for household use only. Do not
use this appliance for anything other than its
intended use. Do not use in moving vehicles or
boats. Do not use outdoors.
• The installation of a residual current device
(safety switch) is recommended to provide
additional safety protection when using electrical
appliances. It is advisable that a safety switch
with a rated residual operating current not
exceeding 30mA be installed in the electrical
circuit supplying the appliance. See your electri-
cian for professional advice.
Do not operate the Blender
continuously on heavy loads
for more than 30 seconds.
Step 2.
To reassemble the blender jug, replace the silicon
seal onto the blade assembly (see Page 39 - Fig 1).
Upturn the blender jug and insert the blade
assembly into the jug base (see Page 39 - Fig 2).
Twist the Blade Removal System anticlockwise until
firmly locked into position.
Step 3.
Turn the blender jug upright and insert on to the
motor base. The handle of the blender jug can
be positioned to the left or right hand side of the
appliance.
Step 4.
Add food or liquid into the blender jug ensuring
not to exceed the 'MAX' mark. Place the blender lid
firmly into position on the top of the blender jug.
Insert the clear inner lid into the blender lid and
turn clockwise to lock into position. (see Fig 1)
When adding oil or other liquids during opera-
tion, turn the lid to the unlocked position and
pour through the small holes on either side of the
inner lid (see indents for finger placement Fig. 1.)