Mains Connection - Gartenmeister GM EMR 550 Gebrauchsanweisung

GB ENGLISH
Connection and extension cables should be kept away
from the cutting device to avoid damage which could lead
to contact with live parts.
The ON/OFF switch and safety switch must not be locked.
Stop the device and disconnect it from the power supply
• whenever you leave the lawnmower
• before removing blockages
• efore checking, cleaning or working on the device
• after contact with a foreign object, to check the device
for damage
If the appliance starts abnormally vibrating, switch the
engine off and search for the cause immediately. General-
ly, vibrations are a warning against operating failure.
When being blocked, turn the appliance immediately off
and remove the jammed item.

MAINS CONNECTION

DANGER!
Operation is only allowed with a safety switch against
stray current (RCD max. stray current of 30mA).
Before use check machine, cable, and plug for any dama-
ges or material fatigue. Repairs should only be carried out
by authorised Service Agents.
Insert the plug of the electrical cable in a socket of suitable
shape, voltage and frequency complying with current
regulations.
Keep the connection and extension cables away from
dangerous moving parts to avoid damaging them.
Only use splash proof extension cables approved for
outdoor purposes. The stranded wire cross-sectional area
of the extension cable must be at least 1.5 mm
up to 25 m and 2.5 mm
Only plug-in when machine is switched off.
The device is only intended for use on premises that have
a continuous current carrying capacity of >=100 A per
14
2
for cables above 25 m.
2
Carry the weed sweeper with the handle, with the blade
being off (idle). The battery must be removed for transport
or storage of the weed sweeper. Careful appliance hand-
ling reduces the risk of injury by knife.
The appliance must be stored in a dry place and protected
from frost.
Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool.
phase and are supplied from a electrical grid with a rated
voltage of 400/230V.
If necessary, please consult your electricity company to
ensure that the continuous current carrying capacity of
the mains at the connection point is sufficient for connec-
ting the device.
WARNING
WARNING! Electric shock! There is a risk of an injury
caused by electric shock!
Do not use the device if the cable or plug is damaged or
worn.
If the cable is damaged during use, it must be discon-
nected from the mains supply immediately. Do not touch
the cable until it has been disconnected from the mains.
Do not connect a damaged cable to the power supply
for cables
and do not touch a damaged cable before disconnecting
it from the power supply, as damaged cables can lead to
contact with active parts.