Pellini ScreenLine SL2776 Installationanweisungen Seite 20

Memorizing a channel
1. Detach the battery module from its
base plate;
2. Select the required channel on the
remote control display by pressing the
+/- buttons;
3. Using a sharp tool, such as the end of
a paperclip, press the programming
button on the battery module (see
image opposite) for 3 seconds, until
the yellow LED on the up arrow turns
on and immediately off;
4. Within 20 seconds hook the battery
module onto the base plate to be
memorized;
5. The yellow LED will remain steadily on and, within 10
seconds, it will be necessary to send the association
command by pressing the up and down push buttons
simultaneously on the remote control, until the green
LED on the battery module flashes quickly.
Deleting a channel
1. Detach the battery module from its base plate;
2. Call up the channel to be deleted on the remote control
display by pressing the +/- push buttons;
3. Press the programming button on the battery module
for 3 seconds, until the yellow LED on the up arrow turns
on and immediately off;
4. Within 20 seconds hook the battery module onto the
base plate to be memorized;
5. Wait 10 seconds, until the yellow LED on the up arrow
turns on and starts flashing quickly;
6. Within 10 seconds send the cancellation command of
the desired channel by pressing the up and down push
buttons simultaneously on the remote control, until the
LEDs on the battery module flash green quickly: the
chosen channel has been deleted.
Deleting all channels
1. Detach the battery module from its base plate;
2. Press the programming button on the battery module
for 3 seconds, until the yellow LED on the up arrow turns
on and immediately off;
20
Programming
button