Pellini ScreenLine SL2776 Installationanweisungen Seite 19

When the charger is connected,
the LED will indicate the
following conditions:
• LED pulsating: charging
underway
• LED steadily lit: charging
completed
After charging, detach the cable
and fit the module back onto its
base plate.
In case of a new battery, 2-3
full charging/discharging cycles
may be necessary to bring the battery to its full capacity.
MEMORIZING RADIO CHANNELS AND OPERATING MODE
The information relating to the radio channels and the
operating mode of the blind is saved on a memory card
housed in the battery module base plate (namely, the fixed
part applied on the glass or the window frame, which is
connected to the blind).
N.B.: if several blinds and several battery modules are
installed, it is not necessary to always reposition each
battery module onto its corresponding base plate, since
the remote controls and channels are associated with
the base plate and not with the battery module. Once
positioned on the base plate, the battery module will read
the information from the latter. Likewise, when a battery
module is replaced, its reprogramming is not required, as
the necessary information will be automatically provided
by the base plate.
To write information onto the base plate, please follow the
instructions below.
PROGRAMMING THE SCREENLINE REMOTE CONTROL
(OPTION)
The battery module is equipped as standard with a
radio receiver for remote control. A 99-channel radio
transmitting board is used for the remote control. The
radio receiver housed in the battery module can memorize
up to 26 channels; it can thus receive an equal number of
addresses from one or several remote controls.
Activation
push buttons
with LED
Micro USB
19