Lighting Technologies DOMO LED 12 Montageanleitung Seite 5

INSTALLATION AND OPERATION RULES
The luminaire should be used according to «Standard code of customer electrical installations».
Installation, cleaning and replacing of the components should be done only with the main power
off. The diffuser should be cleaned with soft cloth and mild detergent.
1. Tools needed.
2. Switch mains power off. Unpack the luminaire.
3. Mark mounting holes at bearing surface according to bracket size (use builder's level if
needed). Drill the holes.
4. Place anchor dowel(1)(included) into holes on bearing surface, fix luminaire bracket at bearing
surface with 3.9x25 self-tapping screw(2)(included).
4.1. When necessary, make adjustments to the motion sensor (luminaire version with motion
sensor is DOMO LED MS), having control gear box cover previously removed (release 6 M3
screws). Sensor adjusting instructions - see p. 9 "Installation and operation rules" section.
4.2. Fix control gear compartment cover (ATTENTION! When placing the cover the seal in the
cover's slot shouldn't be jammed) by six M3 screws with 1Nm of torque.
5. Attention! The luminaire should be installed with arrow facing down.
5