Installation - SAB ELLIPSE Gebrauchsanleitung

The espresso machine Ellipse is to be installed to comply with the applicable
federal, state or local plumbing codes having jurisdiction.
The manufacturer has tried to foresee all possible safety devices to ensure the safety of the users.
Anyhow different conditions of installation or of equipment moving can cause situations which cannot be
controlled or foreseen. Therefore it's absolutely necessary to evaluate all remaining risks and to care about
the following:
Installation and maintenance must be carried out by technicians and service providers authorised by
the manufacturer.
The appliance is only to be installed in locations where use and maintenance is restricted to trained
personnel.
Any defect or discrepancy has to be notified immediately to the authorised persons for installation
and maintenance.
A residual current device (RCD) having a rated residual operating current not exceeding 30mA must
be installed.
This machine is safe only when it has been correctly connected to an efficient grounding /earthing
system, implemented in accordance with the current safety regulations.
All electrical connections have to be effected exclusively by authorised and qualified technicians. Any
improper cable connection is forbidden.
Check the integrity of all components and do not install defective or damaged parts. Ask for
replacement.
Check that capacity of the electrical system is sufficient for the maximum rated power shown on the
data rating plate of the machine.
The customer has to protect the electrical feeding of the machine by means of a safety switch
system of 30 mA.
The machine must be installed with an electrical switch with adequate fuses and safety devices.
The machines with electrical input over 16 A, must be connected to a net with impedance
= or < than 0,37 Ω.
The machine has to operate with clean soft drinking water. Building up of scale will seriously damage
this equipment and can also cause injuries. If necessary, install a inlet filter.
Before installation, the manufacturer strongly recommends to control the water supply system and
the electrical connections.
Check the efficiency of the machine's main drain. Then proceed with the connection of the water
drain hose to the machine. Check again pouring an adequate quantity of water directly into
machine's drain tray (located under the drip tray).
This equipment must be installed on a flat, level and stable surface. The minimum height of this
surface is 1025 mm
Handle the machine with care.
Do not leave such packing items as plastic bags, styrofoam, nails, etc. around because children or
other people could get hurt or damaged.
In case of substitution of the water inlet hose, the used one is not to be reused.
Downloaded from www.Manualslib.com
Manuale Utente – User manual – Gebrauchsanleitung - Macchina caffè modello ELLIPSE
Con riserva di modifica - Specification subject to change – Änderung vorbehalten
manuals search engine
ed 2011 – Pag. 19 di 41

Installation