SOUNDMASTER TR60 Bedienungsanleitung Seite 4

Use
1) Power On/Off , Volume
2) Knob for sound adjustment
Band knobs FM/MW/SW/LW
3)
4) Tuning Control
5) Rod antenna
6) AC Power cord jack (backside of unit)
7) Battery Compartment (backside of unit)
Connection with the unit
* Check the characteristics of the AC power(230 V 50 Hz).
* Place the apparatus in a sure place while taking care to preserve a sufficient space of
ventilation all around the apparatus (10 cm) so that the heat generated at the time of
operation can be evacuated without obstacle.
* Connect the AC power cord with the back of the apparatus (6) and on the unit.
* When the apparatus is connected on the AC, withdraw the Battery.
Operation with Battery
Open the battery compartment (7) located at the back of the apparatus and introduce 6
battery 1,5 V of the type UM-2/C while taking care not to reverse the poles. Then, close
again the compartment.
Always change complete set of batteries and never mix used with new once.
To avoid any damage of unit, by using only AC or long term no use of radio, take out the
Batteries of the radio.
Radio Mode
Important : In mode FM / SW, fully extent the rod antenna (5).
1) To turn on the unit: Turn the Power ON/OFF button (1) clockwise
Choose the range of waves using the buttons - Selector knobs of the bands
2)
3) Adjust the station using the tuning control (4).
4) Adjust the sound using the sound knob (2).
5) Use the Volume knob (1) to adjust the volume as desire.
To turn off the unit: Turn the Power ON/OFF button (1) anticlockwise until you hear
6)
"click" sound.
Design features
FM
AM/MW
SW
LW
Operation on AC
Operation on DC
Powerconsumption
Outputpower
Specification are subject to change without notice
Copyright by Wörlein GmbH, D-90556 Cadolzburg, Germany
ENGLISH
87,5 – 108 MHz
530 – 1 600 KHz
6 – 18 MHz
150 – 285 KHz
230 V AC 50 Hz
9V 6 x UM-2/C 1,5V (batteries not included)
7 W
10 W P.M.P.O.
(3).