Wiseup WIFI28 Benutzerhandbuch Seite 7

mobile device to another WIFI hotspot, or you can turn off the WLAN function and use your
mobile network.
3. Launch the "BVCAM" APP again. If the camera shows "Online" on the "Live video" page, it
means the remote view setup is successful and the camera has entered into WAN mode. You
can view the camera's remote live video.
[Note]:
If the camera shows "Device Offline", that means the remote view setup failed and you need
to reset the camera (See VIII) and set up all over again.
V. Motion Detection Recording Setup
>> Please make sure that the camera is added to the APP in LAN or WAN mode before you
start.
5.1. Launch the "BVCAM" APP.
5.2. Set up motion detection photograph as below:
Step1: Tap the setting icon on the "Live video" page then choose "Advance Config" or
"Device Settings".
Step 2: Go to "Alarm Config" page, there, you can set a desired alarm sensitivity level, alarm
schedule, and alarm interval time. Enabling the "Warning Tone", "Push Notification" and
"On-screen Display" is also available.
Step 3: Tap "OK" to complete the setting.
Downloaded from www.Manualslib.com manuals search engine