Specifications - Maktec MT431 Benutzerhandbuch

ENGLISH (Original instructions)
1-1. Cutting action changing lever
2-1. Switch trigger
2-2. Lock button
3-1. Blade holder
3-2. Bolt
3-3. Hex wrench
4-1. Bolt
4-2. Roller
4-3. Blade
5-1. Hook
5-2. Hex wrench
6-1. Cutting line

SPECIFICATIONS

Max. cutting capacities
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for the sawing of wood, plastic and
metal materials. As a result of the extensive accessory
and saw blade program, the tool can be used for many
purposes and is very well suited for curved or circular
cuts.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Downloaded from www.Manualslib.com
Explanation of general view
6-2. Base
8-1. Hex wrench
8-2. Bolt
8-3. Base
9-1. Edge
9-2. Graduation
10-1. Hex wrench
10-2. Bolt
10-3. Base
14-1. Hose
15-1. Rip fence (Guide rule)
16-1. Hex wrench
Model
Length of stroke
Blade type
Wood
Mild steel
-1
Strokes per minute (min )
Overall length
Net weight
Safety class
) : 82 dB(A)
pA
) : 93 dB(A)
WA
Wear ear protection
manuals search engine
ENE019-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting boards
Vibration emission (a
ENF002-1
Uncertainty (K) : 1.5 m/s
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
ENG905-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
4
16-2. Bolt
16-3. Fence guide
16-4. Rip fence (Guide rule)
17-1. Threaded knob
17-2. Fence guide
17-3. Rip fence (Guide rule)
17-4. Pin
18-1. Rip fence (Guide rule)
19-1. Anti-splintering device
19-2. Protrusion
MT431
18 mm
B type
65 mm
6 mm
0 - 3,100
214 mm
1.9 kg
/II
2
) : 8.0 m/s
h,CW
2
2
) : 5.0 m/s
h,CM
2
ENG900-1
ENG901-1