PROLED RF RGBW2 REMOTE CONTROLLER Bedienungsanleitung Seite 8

5. Usage
Press once to change between warm white, natural white
and white as a mixing of RGB-colours
Touch the colour wheel to choose desired colour.
Play/Pause button. Press Play/Pause to stop the current program
un to change to next of 10 build in programs.
Press and hold the button to change the speed of current program.
4 Zones: Press to choose the desired zone,
press and hold the desired zone to set it OFF or ON.
Press and hold the desired buttonto save colour / scene /
mode. Press again to recall the settings.
Program saving
W+
zone
1 2 3 4
R G B W
scene
S1 S2 S3 S4
If you want to controll more receivers, you have two possibilities:
Possibility 1: All receivers have same zone, e. g. Zone 1
RF LED Receiver
Learning Key
Zone 1
Possibility 2: Jevery receiver has different zone, e. g. 1, 2, 3 or 4
RF LED Receiver
Learning Key
Zone 1
RF LED Receiver
Learning Key
Zone 3
MBN GmbH, Balthasar-Schaller-Str. 3, 86316 Friedberg - Germany
07.19. Technical amendments reserved
Touch the brightness slider
to change RGB-brightness.
Press to set OFF or ON all zones
Step 1: Press ON/OFF to activate the remote controller
Step 2: Press one or more connected zones (e.g. zone 4)
Step 3: Press button P. LEDs connected to receiver will blink once
Step 4: Touch the colour wheel to choose 2-5 colours (max. 5 colours)
Step 5: Press button P again, to confirm choosed colours.
LEDs connected with receiver will blink again to confirm programming.
Step 6: Press button to start the program
RF LED Receiver
Learning Key
RF LED Receiver
Learning Key
Zone 2
RF LED Receiver
Learning Key
Zone 4
www.proled.com
Bedienungsanleitung / User's manual
Press to start programs in 4 different mods:
W+
jump, flash, fade and strobe
Programing: Press the button. LEDs connected to receiver will blink
once. Next press 2-5 different colours on the colour wheel.
Then press P-button again. The LEDs connected to the receiver will
blink once to confirm ending of programming.
zone
Press button
1 2 3 4
R, G, B, W Channels: Press to set ON or Off the corresponding
channel. Press and hold the button to increase or decrease the
R G B W
brightness of the desired channel.
scene
S1 S2 S3 S4
Front side
How to stop running mode of single color LED light
caused by RGBW sender interference:
1. When pairing single color LED light to a single color
remote, it might be interfered and paired by nearby RGBW
senders, which might control the single color light into
running mode. The running mode can not be stopped by the
paired single color remote or by deleting pairing.
RF remote
2. Then we need this remote, and pair the remote to the
receiver via above "Connecting RF remote controller
with RF receiver (Method 2)", then touch the color wheel
to stop the running mode.
3. Then delete pairing and pair the receiver to the single color
remote again. It can be controlled by the remote again.
RF remote
to start the program.