Spare Parts; Cleaning And Maintenance - Stocker 254 Bedienungsanleitung

Trial spraying with clean water and a check of
tank, hose, spraying gun for possible leakage
are required prior to operation. Meanwhile,
a little lubricant grease shall be applied to
the seal ring or other moving parts to reduce
grinding and resistance.
The preparation of chemical shall follow the
instructions and formula furnished by the
pesticide manufacturer. Unauthorized altering
of the dilution rate of chemical is prohibited,
which may either endanger the human being
and animal, or result in the failure of pest
control.
Upon the finish of operation, you shall change
clothes and wash those exposed part of body
such as hands and face. In case of highly
toxic pesticide and germicide, a shower after
operation is required to ensure safety.
After use clean sprayer and lance thoroughly
with water and store the sprayer upside
down.
Chemicals and its bottles are to be disposed
in accordance with the manufacturer's
instructions. At the end of the life cycle
dissemble the backpack sprayer and dispose
it's parts at your resource recovery center.
V. Spare parts
Article Description
R-254
Pressure control
T-255
Spray hose
D-255
Brass Jet
G-255
Spray lance 48 cm
V-255
Set O-Rings
P-254
Pumper
VI. Operating instructions
Unscrew the pumper and fill the tank with prepared
chemicals carefully before replacing the pumper on the
tank. Move the pumper up and down to generate pressure,
afterwards you can start spraying.
VII. Cleaning and Maintenance
After use the surface and inner part should be cleaned.
VIII. Storage
The spray should be stored in a dry place indoor out of
reach of children.