Bosch GWS 9-115 P Professional Originalbetriebsanleitung Seite 13

Downloaded from www.Manualslib.com
OBJ_BUCH-1660-005.book Page 13 Monday, August 26, 2013 3:30 PM
Kickback and related warnings
Maintain a firm grip on the power tool and position your
body and arm to allow you to resist kickback forces. Al-
ways use auxiliary handle, if provided, for maximum
control over kickback or torque reaction during
start-up.
Never place your hand near the rotating accessory.
Do not position your body in the area where power tool
will move if kickback occurs.
Use special care when working corners, sharp edges,
etc. Avoid bouncing and snagging the accessory.
Do not attach a saw chain woodcarving blade or
toothed saw blade.
Safety warnings specific for Grinding and Abra-
sive Cutting-Off operations
Use only wheel types that are recommended for your
power tool and the specific guard designed for the se-
lected wheel.
The grinding surface of the centre depressed wheels
must be mounted below the plane of the guard lip.
The guard must be securely attached to the power tool
and positioned for maximum safety, so the least
amount of wheel is exposed towards the operator.
Wheels must be used only for recommended applica-
tions. For example: do not grind with the side of the
cut-off wheel.
manuals search engine
Always use undamaged wheel flanges that are of cor-
rect size and shape for your selected wheel.
Do not use worn down reinforced wheels from larger
power tools.
Additional safety warnings specific for abrasive
cutting off operations
Do not "jam" the cut-off wheel or apply excessive pres-
sure. Do not attempt to make an excessive depth of cut.
Do not position your body in line with and behind the ro-
tating wheel.
When wheel is binding or when interrupting a cut for
any reason, switch off the power tool and hold the pow-
er tool motionless until the wheel comes to a complete
stop. Never attempt to remove the cut-off wheel from
the cut while the wheel is in motion otherwise kickback
may occur.
Do not restart the cutting operation in the workpiece.
Let the wheel reach full speed and carefully re-enter
the cut.
Support panels or any oversized workpiece to minimize
the risk of wheel pinching and kickback.
Use extra caution when making a "pocket cut" into ex-
isting walls or other blind areas.
Safety warnings specific for sanding operations
Do not use excessively oversized sanding disc paper.
Follow manufacturers recommendations, when select-
ing sanding paper.
Safety warnings specific for wire brushing
operations
Be aware that wire bristles are thrown by the brush
even during ordinary operation. Do not overstress the
wires by applying excessive load to the brush.
If the use of a guard is recommended for wire brushing,
do not allow any interference of the wire wheel or
brush with the guard.
13