Troubleshooting; Weak Battery; Command Not Confirmed - eQ-3 Magenta SmartHome Montage- Und Bedienungsanleitung

Troubleshooting

6
6.1
Provided that the voltage value permits it, the window /
door contact will remain ready for operation also if the
battery voltage is low. Depending on the particular load,
it may be possible to send transmissions again repeat-
edly, once the batteries have been allowed a brief recov-
ery period.
If the voltage drops too far during transmission, this will
be displayed on the device (see „6.4 Error codes and
flashing sequences" on page 28). In this case, replace
the empty battery by a new one (see „5 Changing battery"
on page 24).
6.2
If at least one receiver does not confirm a command, the
device LED lights up red at the end of the failed trans-
mission process. The failed transmission may be caused
by radio interference (see „9 General information about
radio operation" on page 30). This may be caused be
the following:
•
•
•
26
Downloaded from www.Manualslib.com
Troubleshooting

Weak battery

Command not confirmed

Receiver cannot be reached.
Receiver is unable to execute the command (load
failure, mechanical blockade, etc.).
Receiver is defective.
manuals search engine