Pattfield Ergo Tools PE-EM 1536 Handbuch Seite 245

8.3 Maintenance
•
Worn out or damaged blades, blade mounts, and bolts should be
replaced as a set by an authorized professional in order to keep
the equipment in balance.
•
Do not clean the lawn mower with running water, particularly with
high-pressure water. Ensure that all mounting components (i.e.
screws, bolts, nuts etc.) are always tightened so that the equip-
ment can be safely operated at all times.
•
Frequently check the grass catch assembly for signs of wear.
•
Replace excessively worn or damaged parts immediately.
•
Store your lawn mower in a dry room.
•
In order to ensure that you enjoy the equipment for many years to
come, all screwed parts, as well as the wheels and axles, should
be cleaned and lubricated.
•
Keeping your lawn mower in good condition not only ensures a
long lifespan and high performance, but also enables the equip-
ment to thoroughly cut your grass with minimal effort. For best
results, clean the lawn mower with a brush or rag. Do not use any
solvents or water to remove dirt.
•
The blade is subjected to more wear and tear than any other com-
ponent. Therefore, routinely check the condition of the blade and
make sure that it is tightly fastened. If the blade is completely worn
out, it must be immediately replaced or ground sharp again. An
excessively vibrating mower means that the blade is not properly
balanced or has become deformed from striking an object. In this
case, the blade must be repaired or replaced.
•
There are no parts inside the equipment which require additional
maintenance.
Anl_PE_EM_1536_SPK7.indb 245 Anl_PE_EM_1536_SPK7.indb 245
- 245 -
GB
26.08.15 09:17 26.08.15 09:17