Pattfield Ergo Tools PE-EM 1536 Handbuch Seite 243

mediately switch off the lawn mower and wait for the blade to come
to a complete stop. Then inspect the condition of the blade and the
blade mount. Replace any parts that are damaged.
Lay the power cable on the ground in loops in front of the power out-
let. Mow away from the power outlet and cable, making sure that the
power cable always trails in the mowed grass so that the lawn mower
does not travel over the cable.
As soon as grass clippings start to trail the lawn mower, it is time to
empty the grass basket. Important! Before taking off the grass bas-
ket, switch off the motor and wait until the blade has come to a stop.
To take off the grass basket, use one hand to lift up the chute fl ap
and the other to grab onto the basket handle. Remove the basket. For
safety reasons, the chute fl ap automatically falls down after removing
the grass basket and closes off the rear chute opening. If any grass
remains in the opening, it will be easier to restart the engine if you
pull the mower back approximately 1m.
Do not use your hands or feet to remove clippings in or on the mower
housing, but instead use suitable tools such as a brush or a hand
broom.
In order to ensure that the majority of grass clippings are picked up,
the inside of both the grass basket and especially the net must be
cleaned after each use.
Reattach the grass basket only when the motor is switched off and
the blade has stopped.
Lift up the chute fl ap with one hand and, holding the grass basket by
its handle with the other hand, hang in the basket from the top.
Anl_PE_EM_1536_SPK7.indb 243 Anl_PE_EM_1536_SPK7.indb 243
- 243 -
GB
26.08.15 09:17 26.08.15 09:17