Pattfield Ergo Tools PE-EM 1536 Handbuch Seite 239

Mounting the grass basket (see Figs. 8a and b)
Press the grass box handle (Fig. 8a/Item 21) into the grass basket as
shown in Fig. 8a. Before you fi t the grass basket you must ensure that
the motor is switched off and the blade is not rotating. Lift the ejec-
tor fl ap (Fig. 8b/Item 3) with one hand. With the other hand, hold the
grass basket by the handle and hook it in from above (Fig. 8b).
Filling level indicator of the grass collector
The grass collector is equipped with a fi lling level indicator (Fig. 1/7)
which is opened by the airfl ow that the lawn mower generates during
operation. If the fl ap closes during mowing, the grass collecting de-
vice is full and must be emptied. To ensure the proper functioning of
the fi lling level indicator, the holes under the fl ap must always be kept
clean and passable.
Adjusting the cutting height
Important!
Adjust the cutting height only when the motor is switched off and the
power cable has been disconnected.
Before you begin to mow, check to ensure that the blade is not blunt
and that none of the fasteners are damaged. To prevent any imba-
lance, replace blunt and/or damaged blades. To carry out this check,
fi rst switch off the motor and pull out the power plug.
The cutting height is adjusted as follows
(see Fig. 9):
1. Push the lever inwards.
2. Set the lever to the desired cutting height.
3. Release the lever and check that it is securely seated in the lock.
Reading off the cutting height
The cutting height can be set between 25-66 mm in 5 intervals, and
can be read off on the scale.
Anl_PE_EM_1536_SPK7.indb 239 Anl_PE_EM_1536_SPK7.indb 239
- 239 -
GB
26.08.15 09:17 26.08.15 09:17