Machine Start And Stop - Nilfisk-Advance EDS BA 551 Betriebsanleitung

Detergent tank filling (for machines with EDS - ECO Dosage Solution)
1. Open the cover (22) and check that the recovery water tank (21) is empty, otherwise empty it with the drain hose (16).
2. Grasp the handle (41) and carefully lift the tank (40).
3. Open the plug (46).
4. Fill the tank (45) with a detergent suitable for the work to be carried out (highly concentrated detergent).
Do not fill the detergent tank completely, leave a few centimetres from the edge.
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
NOTE
If the detergent hose (48) is empty (in case of new system, system emptied for cleaning, etc.), in order to fill
the hose quickly, it may be useful to drain the EDS - ECO Dosage Solution once or several times (see the
procedure in the Maintenance chapter).

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. (Only for BA 551 D, BA 551 CD, BA 611 D): Turn the ignition key (80) to "I" position.
(Only for BA 551): Turn on the machine by pressing the switch (71) and/or (73).
Check that the green warning light (81a) turns on (charged batteries).
If the yellow or red warning light (81b or 81c) turns on, turn the ignition switch back to "0" position and charge the batteries
(see the procedure in the Maintenance chapter).
3. Drive the machine to the working area:
– By pushing it with the hands on the handlebar (2) (only for BA 551).
– By starting it with the hands on the handlebar (2) and pushing the paddle (83) forward to move forward, and backwards
to move in reverse (only for BA 551 D, BA 551 CD, BA 611 D).
The maximum forward speed can be adjusted with the adjuster (84).
4. Lower the squeegee (25) with the lever (10).
5. Lower the brush/pad-holder deck by pressing the pedal (11).
6. Press the brush/pad-holder and vacuum system switch (71).
7. Press the washing water flow control switches (82) as necessary, depending on the type of cleaning to be carried out.
8. Start cleaning, by moving the machine as shown in step 3. If necessary, adjust the maximum speed with the adjuster (84).
Stopping the machine
9. – Stop the machine with the handlebar (2) (only for BA 551).
– Stop the machine by releasing the paddle (83) (only for BA 551 D, BA 551 CD, BA 611 D).
10. Turn off the brushes and the vacuum system by pressing the switches (71 and 73).
11. Lift the brush/pad-holder deck by pressing the pedal (11).
12. Lift the squeegee (25) with the lever (10).
13. Make sure that the machine cannot move independently.
909 6752 000(2)2006-10 A
USER MANUAL
21