Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Disposing Used Test Strip and Lancet
To remove the used test strip, simply press the Test Strip Ejector
to eject the used test strip. The device will automatically turn off
after the test strip is ejected.
To remove the used lancet, remove the lancet from the lancing
device after you have finished testing.
Discard your used strip and lancet properly in a puncture resistant
container.
Important!
The used lancet and test strip may be biohazards. Please consult
your health care provider for proper disposal complying with your
local regulations.
Reviewing Test Results
Your device stores the 1000 most recent test results along with the
respective dates and times in its memory.
To review all test results, do the following:
1. Press and release MAIN. The "
2. Press MAIN to review the test results stored in the device. Press
MAIN repeatedly to review other test results stored in the
device. (r) After the last test result, press MAIN again and the
device will be turned off.
To review the day-average test results, do the following:
1. Press and hold MAIN for 3 seconds until the "
appears. Release MAIN and then your 7-day average result
" icon appears on the screen.
" icon
measured in general mode will appear on the display.
2. Press MAIN to review 14, 21 and 30 day average results stored
in each measuring mode in the order of Gen, AC, then PC. (s)
Note:
MAIN
• Press and hold
for 5 seconds to exit the memory mode or
leave it without any action for 3 minutes. The device will turn off
automatically.
• If using the device for the first time, the "---" icon will appear when
you recall the test results or review the average result. This indicates
that there is no test result in the memory.
• Control solution results are NOT included in the day average.
Announcement of Memory Result by
Universal Tone
Only the most recent result that was saved can be announced
acoustically. If you press the M button to turn the meter on, you
will first hear the Long-Beep which stands for power-on and then
the most recent result.
Only the average for the last 7 days is announced acoustically.
If the 7-day average cannot be calculated, three horizontal bars
are displayed. This is signaled acoustically with 3 long beeps
representing 3 zeroes.
EN-9
Werbung
Inhaltsverzeichnis
Fehlerbehebung
