Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Level sensors
Clean the level sensors occasionally.
Unlock the latches (9) and remove the top
section (1).
Clean the level sensors with a soft cloth.
Reattach the top section (1) again and lock
the latches (9).
Troubleshooting
Functional problems are not always the result of unit defects!
Malfunction:
Suction output
impaired.
Unit will not start.
Plastic emptying bag is
sucked onto the filter
the fleece filter bag is
inserted-dust in the tank
with M vacuum cleaners
Do not intervene further, contact a customer service workshop.
Insert the closing plug of the vacuum cleaner into the suctionaperture.
The motor head must be securely fixed to the container (close the latches).
Place the accessories in a suitable plastic bag and seal the plastic bag or
place it in the tool storage compartment.
Plug the ends of the suction hose into each other.
Possible cause/remedy:
Soiled filter
Paper filter full
Tank is full
Nozzle, pipe or
hose is blocked
Plug in the power power socket?
No mains power?
Power cable OK?
Unit hood closed properly?
Has the water sensor switched off?
Set rotary slide to position OPEN ▲
see page 25
Set rotary slide to position CLOSE ▲
see page 24
Transport
27
clean
exchange
empty
clean
Werbung
