Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - Maestro MCD 182 Originalbetriebsanleitung

6.6 Changing the tool (Fig. 6)
Important! Set the changeover switch (3) to its
centre position whenever you carry out any work (for
example changing the tool, maintenance work, etc.)
on the cordless screwdriver.
Ÿ
Open the chuck (2). The chuck opening (a) must be
large enough to hold the tool (drill bit or screwdriver
bit).
Ÿ
Select the suitable tool. Push the tool as far as
possible into the chuck opening (a).
Ÿ
Tighten the chuck (2) and then check that the tool is
secure.
6.7 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Ÿ
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it with
compressed air at low pressure.
Ÿ
We recommend that you clean the device
mmediately each time you have finished using it.
Ÿ
Clean the equipment regularly with a moist cloth and
some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Ÿ
Type of machine
Ÿ
Article number of the machine
Ÿ
Identification number of the machine
Ÿ
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
7