Pioneer LaserMemory DVD-U03S Bedienungsanleitung Seite 10

CONNECTING THE DRIVE IN THE MIDDLE OF A SCSI CHAIN
Sound Board
SCSI HOST
Adapter
Into an expansion slot of
the personal computer
When a SCSI hard disk or other SCSI equipment is installed in the computer, please
connect according to the following method.
¶ Turn off the power supply of the personal computer.
¶ Set the SCSI ID number so that it is different from the ID numbers of all other SCSI
units.
¶ Disable internal SCSI termination (switch #5 = OFF).
¶ Connect the power supply cable from the personal computer. At the time of
connection, pay attention to the cable polarity. Please use a power supply cable
with two or more connectors in parallel.
¶ Connect the SCSI interface cable. At this time, confirm that the pin 1 of the SCSI
connector is connected correctly to pin 1 of the cable. Use a cable with two or
more connectors in parallel.
¶ When a sound board is used, connect the audio output with an audio cable to the
sound board.
WARNING
The power supply of the personal computer must be turned off before
cables are connected.
10
<DRC1095>
En
Audio Cable
SCSI
Interface
Cable
To the power supply of
the personal computer
DVD-U03S
Pin 1
Pin 1
SCSI hard disk
Fig. 4