Technical Specifications - HURAKAN HKN-CDE400 Handbuch

EN
DEAR ALL,
You have purchased a professional equipment unit. Before you start operating it, you
should read and understand this Certificate and keep it during the whole service life.
Please keep in mind that observance of the instructions presented in this Certificate
extends the service life of the equipment and prevents injury of operating personnel.
We hope our recommendations will maximally facilitate operation of the equipment.
APPLICATION
This equipment is intended for catering services and used for baking pancakes.

TECHNICAL SPECIFICATIONS

Model
Voltage, V
Power, kW
Diameter of the
work surface, mm
Number of work
surfaces, pcs
Dimensions, mm
PREOPERATIONAL PHASE
All the packings, booklets, plastic bags, etc. should be removed before first use.
Then, set the thermostat to the maximum value, turn on the equipment and wait for 10
minutes. This annealing procedure will remove any foreign odors that may be present because
the heating elements are coved with the compounds that protect the equipment from external
environmental influences during transportation and storage. Ventilate a room.
ATTENTION!
IT IS PROHIBITED to use the equipment if:
- the power cable is damaged;
- the equipment has fallen or has external damages or doesn't work.
Never place the equipment near other heat sources!
Never leave any foreign objects on the top of the equipment!
Never block the ventilation openings!
The equipment is not intended for building-in!
If the equipment is not used or you are going to clean it – make sure that is disconnected
from the power supply!
IMPORTANT: try not to overheat the work surface – it will help to significantly
increase the service life of the equipment.
SAFETY WHEN CONNECTING
before connecting make sure that:
- the supply voltage corresponds to the required value;
6
HKN-CDE400
220
6
400
2
880x450x230
HKN-CSE400
220
3
400
1
490x450x230
HKN-CSE400C
220
2.2
400
1
400x400x200