Installation; Wiring Instructions - Ecco EW2015R Installations- Und Bedienungsanleitung

Installation:

For best results, select a mounting location between approximately
72" to 96"[1829 mm to 2438mm] from the ground. Once mounted,
angle the lighthead so the boundary line appears in the desired
location as shown in FIGURE 1.
1. Select a mounting location for the unit on a flat surface, and drill
a 5/16" hole.
2. Secure the light head with the supplied hardware.
3. Adjust the unit to face downward as shown and tighten the
screws located on each side of the worklamp.

Wiring Instructions:

Black Wire: Connect to (-) ground
Red Wire: Connect to a dedicated (+) power source with a customer
supplied inline fuse.
See wiring diagram in Figure 2 for details.
FIGURE 1
LENS
VEHICLE
MOUNTING POSITION
BODY
IMAGE SHOWN: EW2015R
WIRING APPLIES TO EW2015R,
EW2025R & EW2030R
FIGURE 2
RED BLACK
GROUND
(-)
(+)
GROUND
Page 2 of 3