Description Of The Device; Operation; Inserting/Replacing The Battery - Omnitronic TM-100 Bedienungsanleitung

4. DESCRIPTION OF THE DEVICE

(1) Antenna
(2) Belt clip
(3) Mic Adj.-control
(4) Battery compartment
(5) Battery cover

5. OPERATION

5.1 Inserting/Replacing the battery

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Insert the battery (1 standard 9 V battery) and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
Downloaded from www.Manualslib.com
1
2
OMNITRONIC
Transmitter
T M-100
3
4
5
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
manuals search engine
®
Typ/Type: OMNITRONIC OMNITRONIC
Transmitter TM-100
Spannungsversorgung/ www.omnitronic.com
Power supply: 1 battery 9 V
B
G000
Gesamtanschlusswert/
Power consumption: Z
RF
max. 2 mW
T 582M
OMNITRONIC SHOWEQUIPMENT GmbH, GERMANY
Carrier frequency:
UHF 798.850 Mhz
mic adj.
OPEN
(6) Operation selector OFF/MUTE/ON
(7) Microphone input socket
(8) Battery-LED
(9) Antenna socket
Caution!
10
6 7 8
OFF ON INPUT LOW BATT
MUTE
9