Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Congratulations on your purchase of the Pet Bicycle Trailer. Please read through this manual
and following the instructions before and during use.
Assembly:
1.
Assembly of the wheels
The wheel assembly may only be carried out by a dealer assembling the trailer for
the first time.
Axle with corrugated washer (1), plain washer (2) and stop nut (3). (Picture 1)
When assembling the axle in the wheel, slide the axle into the hollow axle
underneath the frame until the holes of the axle and hollow axle are aligned. (Picture 2)
Insert the safety pin through the holes in the axle and hollow axle and engage it by turning the
safety clip down. (Picture 3 and 4)
Insert the wheel on the axle. (Picture 5)
Put the corrugated washer (1) and plain washer (2) and tighten up the stop nut (3) fully using
an adjustable wrench.(Picture 6)
Picture 1
WARNING! The axle remains permanently assembled to the wheel. Never remove
the axle from the wheel from now on as the stop nut (3) would not be re-usable.
2.
Installing the Tow Bar
Lift the trailer up. Remove safety pin from back hole in two bar mount. Swivel the tow bar
o.
180
Lock the tow bar into place by re-inserting the safety pin.(Picture 7 and 8)
WARNING! The two bar safety pin must be locked into place before using the trailer. A tow
bar that has not secured properly could loose during travel, resulting in serious injury or death.
Picture 2
Werbung
