Installation Custom Models - Indel Webasto Isotherm INOX DR49 Installations- Und Wartungsanleitung

4.2 Installation Custom models

Custom models with doors equipped for front panelling by the
customer (not supplied by Indel Webasto Marine Srl) are equipped with
2 side mounting brackets for installation.
Follow the instructions below for correct installation:
• Verify installation tolerances for panel application.
• Provide a door locking system to prevent accidental opening. Closure is not
included with supply.
• The refrigerator will be equipped with a mounting kit inside (Fig.5).
• Fasten the three brackets included in the kit on the panel (Fig.6), according to
the distances indicated in the diagrams (Fig.7-8-9).
• Affix the Custom panel to the refrigerator door and centre it horizontally and
vertically using the adjustments on the brackets (Fig.10-11).
• Insert the refrigerator in the compartment, positioning it so that the door panel
is flush with the rest of the unit and tighten the two side mounting brackets (Fig.
12).
• Cover the fastening points with the two plastic plaques provided in the mounting
kit.
56
User Manual