Maintenance - Greencut GTC130X Betriebsanleitung

WARM ENGINE START
1. If the machine is hot, make sure the choke lever is open (
2. If after a few attempts the machine does not start, follow the starting steps with the engine cold.
ENGINE SHUTDOWN
1. Stop accelerating and let the engine idle for half a minute. Turn off the engine by turning the ignition switch
to the STOP position.
WORKING WITH THE POWER TILLER
Before starting work on the machine, check that the burs are not in contact with any objects and that they can move
freely.
AERATED FROM THE GROUND
This machine can remove soil to facilitate aeration. To aerate the earth:
1. Put the motor hoe in the work area.
2. Adjust the height of the depth tube to the desired working height.
3. Start the motor hoe.
4. Accelerate the engine and the burs will start turning.
5. Slightly press down on the motor hoe to nail the depth tube. The more pressure the hoe will move slower
and deeper.
6. Maintain a proper rhythm so that the strawberries have time to crumble the soil.
INSTRUCTIONS FOR USE
• The moving cutters will pull the machine forward, if you counteract this by driving the spur of the motor hoe
further into the ground, the cutters will penetrate further into the ground.
• If the hoe plunges and does not move forward, lift the handlebars so that the spur does not get stuck in the
ground and move the handlebars to the right and left until it releases.
• When working on slopes, always place yourself a little higher than the slope so that the machine is always below
you.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
CLEANING THE AIR FILTER
Dirt in the air filter will reduce the performance of the machine. Check and clean this item. If you notice any damage
or alterations to the filter, replace it with a new one.
ATTENTION: To clean the air filter, the choke position must be in the open ( ) position, otherwise
the choke will break.
) and pull the starter rope until the engine starts.
51
EN