air&me CLEVAIR 2 Bedienungsanleitung Seite 10

ACCESSORIES
FILTRATION CARTRIDGE
To discover at www.airandme.fr
The water filtration cartridge for Clevair 2 re-
duces limescale deposits.
Composed of ionic and cationic beads, it
guarantees healthy and good quality va-
por, eliminating bacteria and viruses.
Easy to use, it is screwed inside the tank cap
and then remains immersed in water.
We recommend that you change it every 4
to 6 months, depending on the frequency
of use of the device and the hardness of the
water used.
AROMATHERAPY
To discover at www.airandme.fr
air & me offers a wide choice of essential oils
made in France.
Let yourself be seduced by the range of
synergies "The Classics" (Anti-Stress, Healthy
Sleep, Pure Air, Relax, Breathe, Au Jardin
and Berlingot), as well as the range "Les Es-
sentielles", 100% natural oils (verbena) sweet
orange, peppermint, eucalyptus).
A way to make the most of your Clevair 2
humidifier while enjoying the benefits of aro-
matherapy.
18
FAQ
Circumstance Reason
> The product is not correctly
plug or there is an electrical
problem.
> There is a problem on the
The product
electrical system of your
does not work
house.
> The tank is empty.
> The tank is not properly
placed.
The power
indicator is lit, but
> The humidity level chosen on
the appliance
the electronic hygrostat or
does not
via HygroSmart® is reached.
produce steam
at the outlet
> There is not enough water in
the tank.
Abnormal noise
> The device is not on a stable
surface.
> The appliance tank must not
be filled from above.
> The tank cap is not properly
The appliance
closed.
leaks
> The seal of the tank cap has
fallen off during filling.
> The room to be humidified is
The humidity
over-sized.
indicated by the
device does not
change
> The hygrometer sensor is dirty.
> The sensors both have a
Humidity and/
margin of error:
or temperature
Thermometer: ± 2°C
seem wrong
Hygrometry: ± 5%
> The product is new.
Moisture
produced has an
> The water in the tank is dirty
unpleasant smell
(stagnant or contaminated).
Solution
> Plug the socket correctly and
check the voltage and the good
functioning of your electrical
system. Avoid multi sockets.
> Fill the tank.
> Push and place the tank properly.
> Add water to the tank.
> Position the tank on a flat and stable
surface.
> Fill the tank as indicated.
> Tighten the tank cap securely.
> Replace the seal in the cap.
> Compare with a third-party
hygrometer to check if the
hygrometer of the device is
defective.
> Clean the hygrometer by blowing
into the sensor hole to dislodge any
dust particles
> Empty the tank and base and wash
and dry both parts before turning
the unit on again.
19