Philips 3100 Serie Benutzerhandbuch Seite 22

English
20
Problem
Coffee does not come
out or coffee comes out
slowly.
The milk does not froth.
The milk is splashing.
The machine seems to
be leaking.
Cause
The coffee exit duct is clogged
The AquaClean filter was not
prepared properly for
installation or it is clogged.
The grinder is set to a too fine
setting.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The machine circuit is blocked
by limescale.
The milk carafe is dirty or not
inserted correctly.
The milk dispensing spout has
not been opened fully.
The milk carafe is incompletely
assembled.
The type of milk used is not
suitable for frothing.
The milk you use is not cold
enough.
The machine uses water to
rinse the internal circuit and
brew group. Some water flows
through the internal system
directly into the drip tray.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
Solution
Clean the coffee exit duct with the
handle of the measuring spoon or a
spoon handle. Then switch the
appliance off and on again.
Remove the AquaClean filter and try to
brew a coffee again. If this works, make
sure the AquaClean filter is prepared
properly before you place it back. Place
back the prepared filter. If this still does
not work, the filter is clogged and needs
to be replaced.
Set the grinder to a coarser (higher)
setting.
Clean the brew group.
Clean the coffee dispensing spout and
its holes with a needle.
Descale the machine.
Clean the carafe and make sure that
you position and insert it correctly.
Make sure that the milk dispensing
spout is in the correct position.
Make sure that all the components
(especially the milk tube) have been
assembled correctly.
Different types of milk result in different
amounts of froth and different froth
qualities. We have tested the following
milk types which proved to deliver a
good milk froth result: semi-skimmed or
full-fat cow's milk, soy milk and lactose-
free milk.
Make sure you use cold milk coming
directly from the fridge.
Empty the drip tray when the 'drip tray
full' indicator pops up through the drip
tray cover (Fig. 27). Place a cup under
the dispensing spout to collect rinsing
water.
Empty the drip tray when the 'drip tray
full' indicator pops up through the drip
tray cover (Fig. 27). Place a cup under
the dispensing spout to collect rinsing
water.