Operation - LaserLiner MultiFinder Pro Bedienungsanleitung

Downloaded from www.Manualslib.com
– The measuring accuracy may be affected when working close
to high voltages or high electromagnetic alternating fields.
Precautions: Use only one MultiFinder Pro within a working
radius of 5 m. Do not use any electronic transmitters or electric
motors in the vicinity.
1
2
3
4
5
1 Insert battery
Open the battery compartmenton the
housing's rear side and insert a 9 V battery.
Correct polarity must be observed.
2

Operation

Switch on: Briefly press the On/Off button (4).
Switch off: Keep the On/Off button (4) pressed for 4 seconds.
AutoShutOff: The device will automatically switch itself off
about 2 minutes after the last measurement.
3 Symbols
Red = Live wire warning
METAL-SCAN and AC-SCAN mode
Green: metal or live wire is nearby
Red: metal or live wire found
STUD-SCAN mode
Red: object is nearby
Green: object found
12
EN
manuals search engine
1 Maximum display
2 VTN display
3 Live wire warning
4 ON / OFF
Switching measuring mode
5 Manual calibration (CAL)
METAL, AC AND STUD SCAN mode
Metal, wiring, object is nearby