Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Working techniques
When cross-cutting a round or irregularly shaped workpiece, it is necessary to
secure the workpiece with a suitable template or holding device and to use a suitable
band saw blade (for cross section)!
17.3.1 Longitudinal cutting of narrow (thin) workpieces
Longitudinal cutting is sawing parallel to the wood fibre. For rectangular cuts (table at right angles
to the saw blade), place the rip fence to the left of the saw blade to guide the workpiece safely along
the fence with your right hand. For longitudinal mitre cuts with an inclined table, attach the parallel
stop to the right of the saw band on the downward side (if the width of the workpiece permits this)
in order to secure the workpiece against slipping.
Use a sliding stick to prevent the hands from being too close to the band saw blade!
17.3.2 Diagonal cut
For diagonal cuts, use auxiliary devices as shown in the illustrations above.
17.3.3 Cutting tenons
17.3.4 Cutting wedges
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-BAS205 /
ZI-BAS25044
C A U T I O N
1
1 Stop, fixed to the table
OPERATION
44
Werbung
Inhaltsverzeichnis
