Memory Function - Pando PHM9500 Bedienungsanleitung

Special functions
Important Notes:
 Always use dishes for use in the microwave
oven and a lid or cover to avoid loss of
liquids.
 Stir or mix the foods several times during
heating, especially when the oven emits a
beep and the display is flashing as follows:
.
 The time required to heat the food will depend
on its initial temperature. Food taken straight
from the fridge will take longer to heat up

Memory function

Define and store a memory
1. With the Function Selector (1), Select one
of the Basic functions.
2. Set the desired parameters with the
Rotating Knob (8)
3. Press the Clock key (5) for 5 seconds. The
memory symbol "M1" starts blinking.
4. With the Rotating Knob (8) select in which
memory you want to store the defined
parameters (M1, M2 or M3)
5. Press the Ok Key (4) to confirm and store
the memory.
than food
If the food temperature is not what is wanted,
select a greater or lesser weight next time you
heat up the food.
 After heating, stir the food and then leave the
food to stand for some time to allow the
temperature to become uniform throughout the
food.
Warning! After heating the container may be very
hot. Although microwaves do not heat up most
containers, these may heat up through heat
transmission from food.
9 10
Recalling a memorized function
1. Rotate the function Selector (1) to select
the stored memory.
2. Press the start Key (3). The oven will start
to operate.
Delete a memory
1. With the oven in stand-by select the desired
memory by turning the Function Selector
(1).
2. Press the Clock key (5) for 3 seconds. The
power/weight display shows the message
DEL"
"
for 3 seconds.
that is at room
:
EN
temperature.
14