Operation; Powering Up Light Source; Lamp Life Hours Display; Cleaning - Sunoptics Surgical Titan 300 Bedienungsanleitung

6. OPERATION

6.1 POWERING UP THE LIGHT SOURCE
To operate the light source: Attach the light source to the instrument or headlamp.
Turn on the rear power switch. Turn on the lamp switch The fan will start. The indicator
on lamp switch will light.
6.2 LIGHT BRIGHTNESS DISPLAY AND CONTROL
The light brightness adjustment enables the user to obtain a brighter or darker
illumination of the object of observation.
Adjust the light intensity by turning the intensity control knob.

6.3 LAMP LIFE HOURS DISPLAY

The hour meter shows the total elapsed running time of the unit.

7. CLEANING

NOTE
The control unit can be cleaned with any cleaning agents, which are used for external
cleaning of electric equipment, according to instructions given by the manufacturer of
the cleaning solution.
Do not allow excessive moisture or liquids to come in direct contact with the control unit.
Do not use cleaning agents that are not permitted for use with plastics, i.e., ammonia,
acetone, salty acids (HCl), etc.
Do not allow cleaning agents or liquids to enter the control unit outlets.

8. DISINFECTION

8.1 DISINFECTING THE UNIT
NOTE
Use any disinfectant agents which are commonly applied while disinfecting surfaces of
electric medical equipment. Such disinfectant agents usually arrive in the form of
sprays or damp cloths. Follow the instructions given by the manufacturer of the
disinfectant solution.
LIT125Sunoptics Surgical
(English)
Downloaded from www.Manualslib.com
Always disconnect the power cord before cleaning the system.
Always disconnect the power cord before cleaning the system.
®
manuals search engine
Rev. D
Page 9 of 60