ECOFOREST ecoGEO Benutzerhandbuch Seite 45

Outdoor temperature
OutdoorT:
47
Outdoor StopT
Heating:
Active cool:
Passive cool:
oom terminals
SetT ealT
 
T: 5 498
T: 45 4
T3: 45 43
T4: 35 35
Inercia XXXXXX
Treal:
Tconsigna:
DTinicio:
XXXXXX groups
SetT ealT
 
DG: 5 498
SG: 45 4
SG3: 45 43
SG4: 35 35
DHW
ealT:
3
SetT:
DTstart:
94
Start comp T:
Pool
State
Tsup:

SetT:
XXXXXXX meter
5 kW

 kW
 kW
Active demands
58
Version
Version:
Date:
Bios: 4
Boot: 45
Version firmw:
Firware version:
Outdoor temperature
47
Shows the current outdoor temperature and the outside temperatures for heating and
cooling cut-off.

8
3
Room terminals
H
%
In installations with interior terminals equipped with bus communication (Th-T or TH
3
sensors), it displays the interior setpoint temperature (Tcons), the current temperature

3
(Treal) and the current relative humidity (HR) of the terminals assigned to each outlet unit.
94
Heating buffer / Cooling buffer
This shows the setpoint temperature, the start-up temperature differential and the current
499
temperature of the buffer storage tank.
5
There are separate screens for the heating and cooling buffer storage tanks.
5
Heating groups / Cooling groups
eg
%
This shows the target outlet temperature (SetT), the current outlet temperature (RealT)
 and the regulation percentage (Reg) of each outlet unit.
3
There are separate screens for the heating and cooling outlet units.
94
DHW
479
This shows the setpoint temperature, the start-up temperature differential and the current
48 temperature of the DHW storage tank.
5
43
Pool
Off
Shows whether the pool is On or Off Shows the outlet temperature to the pool and the
3 setpoint temperature.
37
Instant meter / Monthly energy meter / Year energy meter
These screens show information regarding heat pump consumption, power, energy
OP: 58
supplied and energy performance.
E: 
It has screens with information about the current moment, each month and by year.
PF: 58
Active demands
The upper part shows current demands for compressor start-up.
The bottom part shows the demands received by the heat pump to start the various outlet
units.
Active demands for the compressor or the outlet units do not imply that they will switch
on. There may be other reasons that prevent them from starting up.
Version
5B
//5
This shows information about the application installed in the controller.
5//4
4//3
5

45
User manual