Distybox 300; Automatic Registration - Disty Box 300 Bedienungsanleitung

Operating instructions
Downloaded from www.Manualslib.com
4. Connect the
5. Fit distybox
The distybox
station before it can be used. The registration process can
normally be carried out using the "Automatic registration"
function.
"Programming mode" allows you to set various parameters
to modify the
base station. Additional parameters allow the distybox to be
set according to your personal preferences. Manual registra-
tion can also be carried out in this mode.

Automatic registration

The distybox
it has not been registered on any other base station yet.
To do this, the PIN on your base station must be set to "0000"
or "1111".
1. Connect the power supply unit (adapter) to your
distybox
300
2. Connect your telephone to the
handset on the hook.
3. Ensure that your base station enables an additional
cordless phone to be registered.
4. During the registration process, the
located close to your base station.
5. Start the registration procedure for the device on your
DECT / GAP base station as if you were registering an
additional cordless unit. Instructions on how to do this
will be given in the operating manual for your base station.
6. Plug the power supply unit into a power socket.
The registration process will be started automatically.
manuals search engine
to the power supply.
distybox 300
in place.
300
300 must be registered on your DECT / GAP base
to suit the functionality of your
distybox 300
can be registered automatically, assuming
300
.
distybox 300 , leaving the
distybox should be
300
EN
19