Faller 144065 Anleitung Seite 4

4
This package contains figures (unpainted), one vehicle, one or two trees, one building, ground cover materials,
terrain building adhesive and one terrain part for building a small diorama.
Plastic adhesives and paints not included.
For erection of the building, use FALLER EXPERT Art. No. 170492 only.
After completion of the model (Pos. A - G), apply plastic adhesive to the bottom edge of the building and, as shown
on the rear side of the package, mount the model and the tree on the terrain part.
Visible cemented joints, if any, can be concealed somewhat by applying ground cover material at a later time.
For greening the terrain part, lay out ground cover materials and the accompanying terrain building adhesive ready
and handle all this according to the following instructions:
First, apply terrain building adhesive evenly thin to the paths and sand surfaces to be created. Then spread the
available sand over the surface with the still wet adhesive (and apply slight pressure with a finger).
Now treat the surfaces to be greened in the same way and evenly apply the ground cover material to the most
cemented surface to obtain full coverage and also wait until the surface is completely dry.
Then turn the terrain part upside down and knock off the loose residual ground cover material (Pos. H).
You can now paint the unpainted figures with commercially available model-making paints.
For fitting the figures and the vehicle, cautiously scrape off the cemented surfaces in the terrain covered with
ground cover material and glue the parts to these surfaces (Pos. L).
You are free to choose your own configuration of the individual parts.
Have lots of fun with your finished diorama.