Werbung
INSTALLATION
1. Loosen the two thumb screws (one on each side)
several turns and remove the mounting bracket
from the speaker.
2. Temporarily position the speaker and the
mounting bracket to verify the desired mounting
location. Make sure the speaker will not interfere
with the desired operation of the vehicle
(preferable placement is on the passenger side of
the vehicle) and that the speaker front is not
blocked by sound absorptive material. Using the
mounting bracket as a guide, mark two holes on
the transmission hump or other selected location.
3. Using an awl or other similar device, open two
holes in the carpet at the marked locations. This
must be done prior to drilling to avoid ruining the
carpet.
4. Using a 5/32" bit, drill the two mounting holes and
secure the bracket using the two 10-16 x 5/8"
tapping screws and washers provided.
5. Mount the speaker to the mounting bracket.
Securely tighten the two thumb screws.
6. Route wires through connector as shown in
Figure 1a, or for applications with multiple
accessories connected to the mobile radio, route
wires as shown in Figure 1b and use the cable tie
to secure wires to the connector after completing
step 7.
7. Insert the contacts into pin locations #9 and #10
on the accessory connector as shown in Figure 2.
2
Werbung
