Hama FUNSTAND 57 Bedienungsanleitung Seite 7

6.2. Automatic Bluetooth
Note
• Make sure that your Bluetooth
is activated.
• Make sure that your Bluetooth
Bluetooth devices.
®
• For more information, please refer to the operating instructions of your terminal
device.
• The Bluetooth
last paired with.
• Press and hold the on/off button (2) for approx. 3 seconds to turn on the Bluetooth
remote release. The indicator light (1) begins to flash blue.
• After 3–5 seconds, the Bluetooth
device.
• You can now use the Bluetooth
Note – Connection impaired
After the devices have been paired once, the connection is then established
automatically. If the Bluetooth
the following:
• Check the Bluetooth
Funstand57 is connected. If not, repeat the steps listed under 6.1. Bluetooth
pairing.
• Check whether obstacles are impairing the range. If so, move the devices closer
together.
• The performance can also be affected by a weak battery. Change the battery
if necessary.
• Only one Bluetooth
connection to another device, deactivate this connection and try again.
6.3. Replacing the batteries
The battery has been designed to last for up to 2,000 shots, although this depends
on the conditions of use. If the Bluetooth
press the release button (2), or does not connect to the terminal device, etc., change the
battery as follows: See (B).
connection (after successful pairing)
®
remote release remains connected to the Bluetooth
®
connection is not established automatically, check
®
settings of your terminal device to see whether hama
®
device can be connected at a time. If there is an active
®
-capable terminal device is on and Bluetooth
®
-capable terminal device is visible for other
®
remote release automatically connects to the
®
remote release.
®
remote release does not respond after you
®
®
device it was
®
®
®
5