Periods Of Non-Operation; Troubleshooting - Electrolux RJX2300AOW Benutzerinformation

10 www.electrolux.com
remove pieces of ice that break away
before defrosting is complete.
4. When defrosting is completed, dry
the interior thoroughly.
5. Switch on the appliance.
6. Set the temperature regulator to
obtain the maximum coldness and
run the appliance for two or three
hours using this setting.
7. Reload the previously removed food
into the compartment.

6.5 Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
The appliance does not
operate.
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
1. Disconnect the appliance from
2. Remove all food.
3. Defrost (if necessary) and clean the
4. Clean the appliance and all
5. Leave the door/doors open to
Possible cause
The appliance is switch‐
ed off.
The mains plug is not
connected to the mains
socket correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
electricity supply.
appliance and all accessories.
accessories.
prevent unpleasant smells.
WARNING!
If the cabinet will be kept on,
ask somebody to check it
once in a while to prevent
the food inside from spoiling
in case of a power failure.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock‐
et. Contact a qualified elec‐
trician.
Check if the appliance
stands stable.
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.