Lifting And Moving The Tv - LG 55LH57 Serie Benutzerhandbuch

Preparing
NOTE
If the TV is turned on for the rst time after it was shipped from
the factory, initialization of the TV may take a few minutes.
(Depending on model)
Image shown may di er from your TV.
Your TV's OSD (On Screen Display) may di er slightly from that
shown in this manual.
The available menus and options may di er from the input source
or product model that you are using.
New features may be added to this TV in the future.
The items supplied with your product may vary depending on the
model.
Product speci cations or contents of this manual may be changed
without prior notice due to upgrade of product functions.
For an optimal connection, HDMI cables and USB devices should
have bezels less than 10 mm thick and 18 mm width. Use an
extension cable that supports USB 2.0 if the USB cable or USB
memory stick does not t into your TV's USB port.
B
A A
Use a certi ed cable with the HDMI logo attached.
If you do not use a certi ed HDMI cable, the screen may not display
or a connection error may occur. (Recommended HDMI Cable Types)
TM
- High-Speed HDMI®/ Cable (3m or less)
TM
- High-Speed HDMI®/ Cable with Ethernet (3m or less)
How to use the ferrite core (Depending on model)
- Use the ferrite core to reduce the electromagnetic interference in
the power cord. Wind the power cord on the ferrite core once.
[Wall side]
10 cm (+ / -2 cm)
This Smart TV is for VOD watching service, some smart functions
may not be supported including web browser. (Only LH57**)
8

Lifting and moving the TV

Please note the following advice to prevent the TV from being scratched
or damaged and for safe transportation regardless of its type and size.
B
<
*A 10 mm
=
<
*B 18 mm
=
[TV side]
CAUTION
Do not use any unapproved items to ensure the safety and product
life span.
Any damage or injuries caused by using unapproved items are not
covered by the warranty.
Some models have a thin lm attached on to the screen and this
must not be removed.
When attaching the stand to the TV set, place the screen facing
down on a cushioned table or at surface to protect the screen
from scratches.
Make sure that the screws are fastened completely. (If they are
not fastened securely enough, the TV may tilt forward after being
installed.) Do not use too much force and over tighten the screws;
otherwise screw may be damaged and not tighten correctly.
It is recommended to move the TV in the box or packing material
that the TV originally came in.
Before moving or lifting the TV, disconnect the power cord and
all cables.
When holding the TV, the screen should face away from you to
avoid damage.
Hold the top and bottom of the TV frame rmly. Make sure not to
hold the transparent part, speaker, or speaker grill area.