Answering A Call; Registering Rfid Tags; Registering An Administrator Tag; Registering A User Tag - Byron DIC-23312 Bedienungsanleitung

A. To unlock your door or gate, simply swipe your administrator or
user tag across the RFID sensor on your doorbell.
ð Your door or gate will now unlock within the time period you set
using the lock release time switch.
6.2

ANSWERING A CALL

When the doorbell rings, you can:
A. Press the gate button to open the gate (optional).
B. Press the lock button to open the door (optional).
C. Press the camera button to make a video or take a picture.
D. Press the talk button to talk to your visitor.
6.3

REGISTERING RFID TAGS

Note: When using the product for the first time, it is not necessary to
register the administrator tags. The tags have already been
registered in the factory. It is only possible to register 2 administrator
tags at a time.

6.3.1 Registering an administrator tag

ü You have an unregistered administrator tag.
ü Your doorbell is plugged in.
ü You have a small screwdriver ready to press the registration
button.
A. Press the registration button on the back of the outdoor unit.
ð The LED will flash red.
B. Swipe the unregistered management tag across the RFID sensor
on the doorbell.
ð The device will beep several times to indicate your administrator
tag has been registered.

6.3.2 Registering a user tag

ü Your doorbell is in standby mode.
ü You have a registered administrator tag.
ü You have an unregistered user tag.
ü You have a door lock or gate opener connected. (Make sure to
switch whether to open the gate or door, on the switch behind
the outdoor unit (door bell)). See section "Connecting a door
lock".
A. Swipe your administrator tag across the RFID sensor on your
doorbell.
B. Within 10 seconds, press the call button.
ð The LED will flash red, and the device will beep.
C. Now swipe the unregistered user tag across the RFID sensor on
your doorbell.
D. Press the call button to exit the registration mode.
ð The device will beep several times to indicate your tag has been
registered.
6.4

CANCELLING A RFID TAG

ü The doorbell is in standby mode.
ü You have an administrator tag ready, and a tag that needs to be
cancelled.
A. Swipe the administrator tag. The LED will light up white.
B. Within 10 seconds, press the call button. You will hear a beep,
and the LED will start flashing red.
Instruction manual
EN
11