Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.
Follow air source manufacturers directions for connections of regulators, filters and
other accessories to air source. Do not install quick couplers directly on tool as they put
unnecessary strain on the air inlet threads possibly causing them to wear out
prematurely. Instead, install them on a short length of air hose attached to the tool.
We cannot accept any guarantee for damages caused by non-observance of these operating
instructions or by improper repair. We reserve the right to make changes in the interest of technical
progress.
I N B E T R I E B N A H M E
1 .
Select lowest torque to solve glow plugs or other sensitive couplings.
Torque settings can be adjusted for this impact wrench in the following 4 steps for the
left rotation: 1 = 10 Nm, 2 = 20 Nm, 3 = 30 Nm, 4 = 40 Nm
2 .
Turn the air regulator to lowest position and increase the performance until the nut or
bolt moves gradually. Warning: If pressing the trigger for longer time and the highest
torque level of the torque controller is set, there is a danger that the glow plug breaks
off when releasing! Always check the torque with a torque wrench by manufacturer´s
instructions.
3 .
Do not tighten nuts or screws with higher torque than allowed. Put nut or screw in the
thread and start attach several revolutions by hand. With the impact wrench tighten the
screw until it rests flush against the supporting surface.
A I R S O U R C E
Clean air of correct air pressure is recommended for the power supply for this tool. A maximum of
90 PSI at the tool is recommended for most air tools of this class. Check specifications section for
recommended pressure. (Depending on length of air hose and other circumstances, air pressure at
compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool.) Water in the air hose
and compressor tank contributes to reduced performance and damage of the air tool. Drain the air
tank and filters before each use and as necessary to keep the air supply dry. Hose length over 25"
causes loss in line pressure. Increase hose ID or increase compressor pressure to compensate for the
pressure loss. Use an in-line pressure regulator with gauge if air inlet pressure is critical.
S 3 2 2 4
7
Werbung
